Table 9. Fwpiaupd Command-Line Arguments For Direct Hsc Update - Intel SR4850HW4 - Server Platform - 0 MB RAM Product Manual

Service Technicians Guide
Table 9. FWPIAUPD Command-line Arguments for Direct HSC Update
Parameter Description
FWPIAUPD The name of the utility.
<hexfile> The name of the hex file for the operation. The path can be specified with the filename,
e.g. c:\mydir\updatfil.hex. There is no default filename or extension.
/? Or /help Displays the command-line help.
/ni Forces non-interactive mode. If the specified operation requires user input or if the
operation is not specified completely the utility will exit with an error.
/nodownrev Prevents the utility from uploading a lower revision of firmware than present in the
system.
/upload Uploads and verifies the firmware.
/verify Verifies the firmware.
/op Applies the specified operation to the operational area.
/primary Selects the primary controller to update/verify with the specified file.
/secondary Selects the secondary controller to update/verify with the specified file.
/inventory
Shows the firmware versions from the specified hex file. If no hex file is specified the -
address option, or the default C0 is used. Shows the HSC Firmware version from a file
and from the controller.
/address=XX Specifies the optional address to use for the inventory command. The address is
specified in Hexadecimal. The default address is C0.
/errlog=file Set a file that the error stack should be written to in the event an error occurs. When
there are no errors "successful termination" is written to the file. The command will
overwrite an existing file. This file is useful for support to troubleshoot any problems that
may occur.
Hidden Options
/devinfo=file Shows the device info block information from the specified hex file. If no hex file is
specified the -address option, or the default C0 is used.
/noverify Skips the verify stage after an update. This is only valid with the update operation.
/nopc Overrides platform checking by disabling the compare of the current flash images
device info block with that contained in the hex file.
/noexit The utility will not exit fw transfer mode after entering it.
132 Intel® Server Platforms SR4850HW4 & SR4850HW4/M Product Guide