Removing And Installing The Center Brace; Removing The Center Brace - Intel SR4850HW4 - Server Platform - 0 MB RAM Product Manual

Product guide
Table of Contents

Advertisement

Removing and Installing the Center Brace

You will need to remove the center brace to perform the following procedures:
Removing and installing a processor core VRM converter (optional step)
Removing and installing the main board
Removing and installing the SCSI backplane board
Refer to the steps to remove and install the center brace when directed in specific procedures.

Removing the Center Brace

1. Observe the safety precautions, warnings, and cautions described in
2. Turn off all peripheral devices connected to the system.
3. Power down the server and disconnect both AC power cords.
4. Remove the top cover. For instructions, see
5. Slide the latches at each side of the chassis to the unlock position. See letter "A" in Figure 91.
6. Lift the center brace from the chassis. See letter "B" in the figure.
Intel® Server Platforms SR4850HW4 & SR4850HW4/M Product Guide
"Safety
"Removing the Top
Cover".
Information".
175

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SR4850HW4 - Server Platform - 0 MB RAM and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents