Installing a Processor Thermal Blank
If a processor and its heatsink are removed from the system, a thermal blank must be installed to
maintain proper airflow within the chassis.
To install a thermal blank:
1. Observe the safety precautions, warnings, and cautions described in
2. Turn off all peripheral devices connected to the server.
3. Power down the server and unplug both AC power cords.
4. Remove the top cover. For instructions, see
5. Remove the processor air baffle. For instructions, see
6. Position the thermal blank on the main board as shown in Figure 94.
7. Use a long Phillips* head screwdriver to lightly engage the four screws.
8. Tighten the four screws to secure the processor thermal blank.
9. Install the processor air baffle. For instructions, see
10. Install the top cover. For instructions, see
Intel® Server Platforms SR4850HW4 & SR4850HW4/M Product Guide
"Removing the Top
Figure 94. Installing Thermal Blank
"Installing the Top
"Safety
Information".
Cover".
"Removing the Processor Air
TP01428
"Installing the Processor Air
Cover".
Baffle".
Baffle".
181