Installing And Removing The Fibre Channel Module; Removing The Fibre Channel Module - Intel SR4850HW4 - Server Platform - 0 MB RAM Product Manual

Installing and Removing the Fibre Channel Module

Removing the Fibre Channel Module

1. Observe the safety precautions, warnings, and cautions described in
2. Turn off all peripheral devices connected to the system.
3. Power down the system and unplug both AC power cords.
4. Remove the top cover. For instructions, see
5. Disconnect any cables attached to the Fibre Channel Module.
6. Remove the memory board or memory board air baffle from Slot C. For instructions, see
Removal of Memory
7. Rotate the retention lever at the rear of the Fibre Channel Module slot into the up position.
8. Pull up on the Fibre Channel Module to remove it.
9. Place the Fibre Channel Module inside a static-free plastic bag on a clean, static-free work
surface.
10. Install an expansion slot cover over the empty slot or install a replacement Fibre Channel
Module:
-
To install an expansion slot cover: align the cover with the slot from the rear of the
chassis. Press the cover into the slot. Rotate the retention lever at the rear of the Fibre
Channel Module slot into the down position.
-
To install a replacement Fibre Channel Module: see
Module".
11. Install the memory board or memory board air baffle into Slot C. For instructions, see
Insertion of a Memory
12. Install the top cover. For instructions, see
Intel® Server Platforms SR4850HW4 & SR4850HW4/M Product Guide
"Removing the Top
Board".
Board".
"Installing the Top
"Safety Information".
Cover".
"Installing the Fibre Channel
Cover".
"Cold
"Cold
151