Configuring R2 Interregister Signaling - 3Com MSR 50 Series Configuration Manual

Configuring R2
Interregister Signaling
Table 88 Default values of signals in R2 digital line signaling
Signal
Idle
Seize
Seizure-ack
Release-guard
Follow these steps to configure R2 interregister signaling:
To do...
Enter system view
Enter E1/T1 interface view
Create a TS set and enable R2
signaling for it
Enter R2 CAS view
Enable the terminating point
to request calling party
information
Configure the number of
digits that should be collected
to request a calling party flag
Adopt Group B signals to
complete interregister
signaling exchange
Enable this end to send a
number terminator to the
terminating point
Configure the special
characters that are supported
during interregister signaling
exchange
Default rx-bits ABCD
1001
0001
1101
1001
Use the command...
system-view
controller { e1 | t1 } number
timeslot-set ts-set-number
timeslot-list timeslots-list
signal r2
cas ts-set-number
ani { all | ka }
ani-offset number
group-b enable
final-callednum enable
special-character character
number
Configuring R2 Signaling
Default tx-bits ABCD
1001
0001
1101
1001
Remarks
-
-
Required
-
Optional
Disabled by default.
Optional
The default for the number
argument is 1.
Optional
Group B signals are used by
default,
Optional
Disabled by default.
Optional
No special character is
configured by default.
2329