Configuring Default Values Of Fax Parameters Globally - 3Com MSR 50 Series Configuration Manual

n
Configuring Default
Values of Fax
Parameters Globally
n
To do...
Configure the capability set of
the voice gateway in H.323
slow start mode to contain
T.38 capability description.
Because NetMeeting does not support T.38 capability description parsing, you
must disable the voice gateway in H.323 slow start mode from containing the T.38
capability description in its capability set to interwork with NetMeeting.
For the use of default values of global parameters, refer to
Default Voice Parameters" on page
Configuration prerequisites
VoIP configuration is completed, IP calls can be made successfully, and fax
machines are connected correctly.
Configuration procedure
Follow these steps to configure default values of fax parameters globally:
To do...
Enter system view
Enter voice view
Enter voice dial program view dial-program
Configure the transmit energy
level of the gateway carrier
globally
Configure the protocol for
interworking with other
devices globally
Configure the maximum fax
rate globally
Configure the fax negotiation
capability globally
Configure the fax training
mode globally
Use the command...
voip h323-conf tcs-t38
2276.
Use the command...
system-view
voice-setup
default entity fax level level Optional
default entity fax protocol
{ t38 | standard-t38 }
[ lb-redundancy number |
hb-redundancy number ]
default entity fax protocol
pcm { g711alaw |
g711ulaw }
default entity fax baudrate
{ 2400 | 4800 | 9600 | 14400 |
disable | voice }
default entity fax nsf-on
default entity fax
train-mode { local | ppp }
FoIP Configuration 2351
Remarks
Required
By default, the capability set
contains T.38 capability
description.
"Configuring Global
Remarks
-
-
-
By default, the transmit
energy level of the gateway
carrier is -15 dBm.
Optional
By default, T.38 (namely,
T.38) protocol is used for fax.
The number of low speed and
high speed redundant packets
is 0.
Optional
By default, the fax rate is
determined by the voice
mode.
Optional
By default, the fax negotiation
is based on the standard
capability.
Optional
By default, the ppp training is
adopted.