Configuring Call Waiting Using Command Lines; Configuration Example - 3Com MSR 50 Series Configuration Manual

2428 C 140: C
HAPTER ALL
Configuring Call Waiting
Using Command Lines

Configuration Example

S C
ERVICES ONFIGURATION
n
Currently, the device supports the call waiting configuration for the FXS voice
subscriber line on telephone terminals. After you enable call waiting on a
telephone, you can view the corresponding operation result by using the display
this command in voice subscriber line view.
Enabling call waiting
Besides you can enable or disable the call waiting feature, you can set parameters
related to this feature, including times a call waiting tone pattern is played,
number of tones in a call waiting tone pattern, and interval for playing a call
waiting tone pattern.
Follow these steps to enable call waiting:
To do...
Enter system view
Enter voice view
Enter voice subscriber
line view
Enable call waiting
Configure call waiting
tone parameters
Configuring a call waiting priority level
To do...
Enter system view
Enter voice view
Enter voice subscriber line view
Configure a priority level for call
waiting
n
Currently, a priority level applies to only the features of call waiting, call
■
forwarding, and hunt group.
By default, the priority levels for hunt group, call forwarding, and calling
■
waiting are 1, 2, and 3 respectively. The smaller the value is, the higher the
priority level is. When you change the priority level of a feature, make sure that
different features have different priority levels.
The call waiting feature is enabled for the voice subscriber line of Telephone A.
Telephone C calls Telephone A which is in a conversation with Telephone B.
Telephone A hears call waiting tones, and Telephone C is not rejected but hears
busy tones and waits for Telephone A to answer the new call.
# Enable call waiting for the voice subscriber line of Telephone A.
Use the command...
system-view
voice-setup
subscriber-line
line-number
call-waiting enable
call-waiting { cwi-count
number | cwi-duration
length | cwi-interval
length }
Use the command...
system-view
voice-setup
subscriber-line line-number
call-forwarding priority level
Remarks
-
-
-
Required
Disabled by default.
Optional
By default, a call waiting tone pattern is
played once, a call waiting tone pattern
contains two tones, and if the value of
cwi-count number is greater than 1,
the interval for playing a call waiting
tone pattern is 15 seconds.
Remarks
-
-
-
Optional
3 by default.