Configuring Basic R2 Signaling Parameters - 3Com MSR 50 Series Configuration Manual

Configuring Basic R2
Signaling Parameters
Figure 675 ITU-T R2 interregister signaling exchange process
Originating side
Calling number : 123
Line signaling exchange
Send called number digit 7 (I-7)
Request next digit (A-1)
Send called number digit 8 (I-8)
Request calling party information (A-5)
Send calling accounting category 2 (II-7)
Request calling party information (A-5)
Send calling number digit 1 (I-1)
Request calling party information (A-5)
Send calling number digit 2 (I-2)
Request calling party information (A-5)
Send calling number digit 3 (I-3)
Request calling party information (A-5)
Send number terminator (I-15)
Request next digit (A-1)
Send called number digit 8 (I-9)
All digits are received completely (A-3)
Send calling service category 2 (II-2)
Subscriber idle and charging starts (B-6)
Line signaling exchange
Configuring the country or region mode
Follow these steps to configure the country or region mode:
To do...
Enter system view
Enter E1/T1 interface view
Create a TS set and enable
R2 signaling for it
Enter R2 CAS view
Configure the country or
region mode
Configuring the trunk direction for R2 signaling
Follow these steps to configure the trunk direction for R2 signaling:
Terminating side
Called number : 789
Use the command...
system-view
controller { e1 | t1 } slot-number
timeslot-set ts-set-number timeslot-list
timeslots-list signal r2
cas ts-set-number
mode zone-name [ default-standard ]
Configuring R2 Signaling
Remarks
-
-
Required
-
Optional
By default, the ITU-T
mode is adopted.
2325