Configuring Basic Rip Functions - 3Com 4500 PWR 26-Port Configuration Manual

Configuring Basic
RIP Functions
Configuring RIP
Route Control
RIP Network
Adjustment and
Optimization
Bas ic IP Configuration R
Config r u ation Prerequisites
Before configuring basic RIP function
Configuring the link layer protocol
Configuring the network layer addresses of interfaces so that adjacent no
each other at the network layer

Configuring Basic RIP Functions

Enabling RIP on the interfaces attached to a specified network segment
Follow these steps to enable RIP on the interfa s attached to a specified network segment:
Enter system view
Enable RIP and enter RIP view
Enable RIP on the specified interface
Task
Enabling RIP on the interfaces attached to a specified
network segment
Setting the RIP operating status on an interface
Specifying the RIP version on an interface
Setting the additional routing metrics of an interface
Configuring RIP route summarization
Disabling the router from receiving host routes
Configuring RIP to filter incoming/outgoing routes
Setting RIP preference
Enabling load sharing among RIP interfaces
Configuring RIP to redistribute routes from another
protocol
Configuring RIP timers
Configuring split horizon
Configuring RIP-1 packet zero field check
Setting RIP-2 packet authentication mode
Configuring RIP to unicast RIP packets
s, perform the following tasks:
To do...
ce
Use the command...
system-view
rip
network network-address
23-3
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
des are reachable to
Remarks
—
Required
Required
Disabled by default