Measuring The End Positions Of The Transfer Carriage; Calibrating The Positions - Dürkopp Adler 806N-111-10 Service Instructions Manual

Service settings via software
6. To keep the file: Press the NO
 The file has not been deleted. You are still on the screen with the file
7. Repeat steps 3 to 5 as necessary.
8. To exit the file directory, press the Exit
 You are returned to the User interface intended for technicians.

9.4.7 Measuring the end positions of the transfer carriage

The machine circumscribes its radius of movement at this point, allowing
you to define a valid work area. The X value and the Y value limit the max-
imum travel path to the left and in downward direction, respectively.
To measure the maximum positions:
1. Press the Measure X-Y
 The machine travels to the maximum positions it can reach.
2. Write down the coordinates if necessary.
3. Press the OK
 The window closes, and you are returned to the User interface

9.4.8 Calibrating the positions

You can use this function to calibrate the important transfer carriage posi-
tions listed below. For a detailed description, refer to the  Operating
Instructions 806N111/806N-121.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
directory.
NOTICE
Property damage may occur!
The machine moves and can be damaged by objects lying in its
travel path.
Do NOT leave any objects in the travel path of the machine.
The following window appears containing the maximum position
coordinates in mm:
button to close the window.
intended for technicians.
button.
button.
button.
151