Table of Contents
Advertisement
4.4.2 Re-engaging the friction clutch
Fig. 15: Setting the friction clutch
(1) - Clamping screw
(2) - Friction clutch
Proper setting
The friction clutch should react when the hook is jammed. The friction
clutch (2) must be set such that it will react at a torque of 4 Nm.
To re-engage the friction clutch:
1. Insert a hexagon screwdriver into the screw located in hole 4 and into
2. Turn the handwheel until the clutch re-engages. Correction
Information
If the clutch reacts too frequently, turn in the two screws (width across flats
3 mm) again that are located on the face of the friction clutch (2). A 1/4 turn
of both screws will increase the torque by approx. 10 %.
36
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
the clamping screw 2.
②
(3) - Hole
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 111
③
Advertisement
Table of Contents
