Setting The Segment End/Seam End Parameters - Dürkopp Adler 878-M PREMIUM Operating Instructions Manual

Icon Parameter
Parameter Seam End
Sewing stop
Adjustments for seam end bartack parameters
Bartack at seam end
Number of stitches backwards
Number of stitches forward
Number of bartack sections
A bartack consists of several sections. If
the sewing direction is changed, a new
section is started. The number of sections
in a bartack can be set here.
Operating Instructions 878-M PREMIUM - 06.0 - 11/2021
6.7.7.2 Setting the Outputs (Output) parameter
This parameter provides virtual outputs that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the
machine.
This parameter cannot be used unless the virtual outputs have been
assigned to a physical output at the Technician level. This requires
that the parameter Additional I/O Configuration can be
configured at the Technician level; for more details, refer to the
explanation in the  Service Instructions.
6.7.8 Setting the
There are various options for setting the Segment End parameters.
The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Segment End/Seam End
Settings
Value range
On/Off
Setting as to what will happen at
the end of a segment/seam.
(see  p. 142)
Value range
On/Off
Value range
01 to 50
Value range
01 to 50
Value range
01 to 99
parameters
139