Setting The Position Of The Roller Lever In Relation To The Control Cam - Dürkopp Adler 806N-111-10 Service Instructions Manual

Machine head 111
4.11.8 Setting the position of the roller lever in relation to the control
Fig. 40: Setting the position of the roller lever in relation to the control cam
(1) - Magnet armature
(2) - Roller
(3) - Control cam
Proper setting
The control cam (3) should not touch the roller lever (4) during the sewing
process.
The distance of the roller lever (4) to the topmost point of the control
cam (3) should amount to 0.1 mm when the magnet armature (1) is fully
extended.
To set the position of the roller lever in relation to the control cam:
1. Loosen the screw (6) on the roller lever (4).
2. Turn the roller lever (4) on the shaft (5) accordingly.
 Make sure that the roller (2) is centered relative to the control cam (3).
3. Tighten the screw (6).
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
cam
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
② ① ⑥
⑤
④
③
(4) - Roller lever
(5) - Shaft
(6) - Screw
63