Setting The Basic Height Of The Middle Slide - Dürkopp Adler 806N-111-10 Service Instructions Manual

Edge folding device
The nozzle (1) housed in the actuator pulls the inner frame and, thus, the
middle slide up into the folding position. This position varies with the material
thickness and can be adjusted using the adjusting wheels ( p. 114).

7.3.1 Setting the basic height of the middle slide

The basic height of the middle slide is important to the folding quality. If the
middle slide is positioned too low, the quality of the folding is good, but the
folding will be undone when the middle slide is pulled out.
If the middle slide is positioned too high, material and middle slide are not
sufficiently sucked. The result is that the folded material will unroll again.
Proper setting
It must be possible to still slightly move the sewing material even if the
middle slide is lowered.
To set the basic height of the middle slide:
1. Access User interface 2 and press the Work step by step
2. Access the User interface intended for technicians and press the
 The overview of all inputs and outputs opens.
3. Place the sewing material onto the sewing material support surface
4. Press the output YC113 (Middle slide forwards).
 The middle slide moves forwards.
5. Press the output YC108 (lower middle slide).
 The middle slide lowers.
6. Check if the sewing material can still be slightly moved.
7. If necessary, correct the basic height of the middle slide.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Output-input button.
located below the middle slide.
button.
119