Table of Contents
Advertisement
Transfer carriage
12. Press the Confirm
The settings have been saved, the submenu closes, and you are
8.2.3 Calibrating the position of the edge folding station
The position of the edge folding station must be calibrated, for example,
following the installation of a new control.
To calibrate the position of the edge folding station:
1. Press the Sewing position folding station
The middle slide moves forward and lowers.
The transfer carriage moves to the edge folding station.
2. Press the Transfer plate up/down
The transfer plate lowers.
3. Use the arrow buttons to align the transfer plate in such a way that the
4. Use the Transfer plate up/down
5. If necessary, correct the position of the transfer plate.
The fields holding the X and Y values will now show the coordinates.
6. Lift the transfer plate again.
7. Press the Confirm
The settings have been saved, the submenu closes, and you are
8.3 Setting the light barrier for reading the transfer plate
If too few or too many fields of the coding field are detected during the
scanning of the transfer plate coding, the light barrier (3) must be set
again.
The light barrier (3) used to read the transfer plate coding is located below
the tabletop. The light barrier (3) reads the transfer plate code through the
hole (1) in the tabletop.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
returned to the Position calibration menu.
Position calibration.
middle slide projects equally far into the sewing contour of the transfer
plate on all sides.
once and to lower it again.
returned to the Position calibration menu.
coding
button to save the settings.
button.
button to lift the transfer plate
button to save the settings.
button in the submenu
139
Advertisement
Table of Contents
