Table of Contents
Advertisement
Stacker
6.7 Setting the air nozzle
The air nozzle should blow down the workpiece rolled from the sewing ma-
terial support surface so that the workpiece is transported to inner shackle
and tray.
If exposed to excess air, the workpiece will drift away, making it impossible
to stack the workpiece. If there is too little air, the workpiece will not reach
its designated position and cannot be stacked.
Proper setting
The air stream should be directed downward in vertical direction.
The air nozzle should serve its purpose at the lowest possible air stream
intensity.
Fig. 85: Setting the air nozzle
(1) - Screw
To set the air nozzle:
1. To correct the blowing direction, set the position of the blower (2) man-
2. To correct the intensity of the air stream, turn the screw (1) on the
3. Watch the blowing direction and the intensity of the air stream while
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
①
②
ually.
throttle valve.
the workpieces are being rolled out and stacked.
(2) - Blower
111
Advertisement
Table of Contents
