Table of Contents
Advertisement
Aligning the transfer plate is important, as the sewing material will other-
wise not be moved properly to the sewing unit following the edge folding
process.
Proper setting
The transfer plate must be parallel to the tabletop when it has been lowered
and depressurized.
To align the transfer plate:
1. Depressurize the machine by pressing the EMERGENCY STOP button.
2. Check the alignment of the transfer plate.
3. Correct the alignment if necessary.
4. Set the screw (1) as necessary.
8.2 Calibrating the positions
A calibration of the transfer carriage positions must be performed if:
Fig. 107: Calibrating the positions (1)
The sticker on the machine shows the coordinates of the positions as set
at the factory. The symbols on the sticker correspond to those displayed
during the calibration of the positions. You can use these values as refer-
ence values when adjusting the positions.
To perform a position calibration:
1. Press the Technician
134
• the machine head was replaced
• the belt was replaced or re-tightened
• the reference point and the limit switches were readjusted
intended for technicians.
X =
Y =
X =
Y =
X =
Y =
button to access the User interface
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Transfer carriage
Advertisement
Table of Contents
