Setting The Swivel Range Of The Thread-Pulling Knife - Dürkopp Adler 806N-111-10 Service Instructions Manual

4.11.7 Setting the swivel range of the thread-pulling knife

Fig. 39: Setting the control cam position
(1) - Magnet armature
(2) - Screw
(3) - Thread-pulling knife
Proper setting
The back of the thread-pulling knife (3) should be flush with the blade of
the counter knife (4) when the magnet armature (1) is fully extended.
To set the swivel range of the thread-pulling knife:
1. Loosen the screw (2) on the clamping block.
2. Turn the magnet armature (1) accordingly.
3. Tighten the screw (2) on the clamping block.
Information
The position of the swung-out thread-pulling knife is determined by the
lowest position of the roller lever (6) when it is in contact with the control
cam (5).
62
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
② ① ⑥
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 111
⑤ ④
③
(4) - Counter blade
(5) - Control cam
(6) - Roller lever