Edge folding device
7.5.2 Setting the height of the corner tucker
Fig. 103: Setting the height of the corner tucker
(1) - Screw
(2) - Corner tucker
Proper setting
The distance between the swung-in corner tucker (2) and the lateral slide
plate (3) should correspond to the thickness of the fabric.
To set the height of the corner tucker:
1. Access User interface 2 and press the Work step by step
2. Press Push button 1 repeatedly until the slides can be moved without
3. Check the distance between the swung-in corner tucker (2) and the
4. Correct the distance if necessary.
5. Loosen the screw (1).
6. Correct the distance between the corner tucker (2) and the lateral slide
7. Re-tighten the screw (1).
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
①
pressure and by hand.
lateral slide plate (3).
plate (3).
②
③
(3) - Lateral slide plate
button.
129