Lubricating (806N-111-10) - Dürkopp Adler 806N-111-10 Service Instructions Manual

Maintenance
Topping up with oil
To top up with oil:
1. Top up the oil via the oil filling neck (3) on oil reservoir 1 (1) until reaching
2. Check the oil feed in oil reservoir 1 (1).
 Bubbles must be visible when the machine is running.

10.3 Lubricating (806N-111-10)

For lubricating the machine, use only lubricating oil DA 10 or oil of equiv-
alent quality with the following specifications:
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
the MAX marking.
WARNING
Risk of injuries from contact with oil!
Contact with oil can cause irritation, rashes,
allergies or skin injuries.
ALWAYS avoid long-term contact with oil.
ALWAYS thoroughly wash the affected areas if
skin contact with oil occurs.
CAUTION
Risk of environmental damage from old oil!
Incorrect handling of old oil can result in severe
environmental damage.
ALWAYS observe the legally prescribed
regulations for handling and disposal of mineral oil.
Take care to ensure that oil is NEVER spilled.
• Viscosity at 40° C: 10 mm
• Flash point: 150° C
2
/s
171