Setting The Adjustment Range Of The Front Adjusting Wheel - Dürkopp Adler 806N-111-10 Service Instructions Manual

7.2.2 Setting the adjustment range of the front adjusting wheel

Fig. 89: Setting the adjustment range of the front adjusting wheel
①
②
(1) - Adjusting wheel rear
(2) - Adjusting wheel front
(3) - Inner frame
Proper setting
When the two adjusting wheels are set to position 0 and the inner frame is
in the folding position, it must be possible to move the front slides under
the middle slide at the smallest distance.
To set the adjustment range of the front adjusting wheel:
1. Turn the adjusting wheel at the front and the adjusting wheel at the
2. Access User interface 2 and press the Work step by step
3. Press Push button 1 repeatedly until the inner frame (3) is situated in
4. Check the distance of the front slides (4) to the middle slide.
5. Correct the distance if necessary: Turn the adjusting wheel at the front
If the front adjusting wheel alone is not sufficient:
6. Loosen the counternut (5) on the bracket of the inner frame (3).
7. Turn the piston rod of the cylinder (6) accordingly.
8. Re-tighten the counternut (5).
116
rear to position 0.
the edge folding station and the front slides (4) can be moved to the
front by hand.
until the proper distance has been reached.
③ ④
(4) - Front slides
(5) - Counternut
(6) - Cylinder
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Edge folding device
⑥
⑤
button.