Setting The Sewing Foot Height - Dürkopp Adler 806N-111-10 Service Instructions Manual

Machine head 121

5.2 Setting the sewing foot height

Fig. 45: Setting the sewing foot height
(1) - Block
(2) - Bolt
(3) - Screw
To set the height of the sewing foot:
1. Press the Lift/lower sewing head
 The sewing head lowers.
2. Press the O button.
 Threading mode is switched on.
3. Remove the head cover.
4. Loosen the wing screw (4).
5. Set the adjusting wheel (5) to the lowest value.
6. Use the handwheel to move the sewing foot to the bottom dead center.
 The distance between sewing foot and throat plate should be 0.5 mm.
7. Loosen the screw (3).
8. Move the block (1) in such a way that the distance between the bolt (2)
9. Re-tighten the screw (3).
10. Replace the head cover.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
②
③
and the lower end of the slotted hole is 1 mm.
④ ⑤
(4) - Wing screw
(5) - Adjusting wheel
button.
71