Setting The Position Of The Swung-In Corner Tucker - Dürkopp Adler 806N-111-10 Service Instructions Manual

Edge folding device
Important
Fig. 100: Corner tucker (2)
(1) - Hole 1
For 806N-111-10:
In this class, you must observe the defined pivot point position.

7.5.1 Setting the position of the swung-in corner tucker

Fig. 101: Setting the position of the swung-in corner tucker (1)
(1) - Corner tucker
(2) - Lateral slide plate
Proper setting
The overlap (3) between the swung-in corner tucker (1) and the lateral
slide plate (2) should be 1-2 mm depending on the type of fabric used.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
①
• Double seam: Pin in hole 2 (2) for a longer stroke
• Single seam: Pin in hole 1 (1) for a shorter stroke
(2) - Hole 2
(3) - Overlap
②
①
②
③
127