Machine head 111
4.5.1 Setting the amount of finger travel
Fig. 21: Bobbin capsule lifter
(1) - Holder
(2) - Nut
(3) - Special wrench
Proper setting
The support of the lever (4) should be off-centered by 3 mm. This will be
ensured when the nut (2) is flush with the outer edge of the shaft.
To set the amount of finger travel:
1. Press the Lift/lower sewing head
The sewing head lowers.
2. Press the O button.
Threading mode is switched on.
3. Use the special wrench (3) to loosen the nut (2) and set the eccentricity
4. Tighten the nut (2).
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
accordingly.
(4) - Lever
(5) - Bobbin capsule
button.
⑤
④
③
②
43