Setting The Alignment Position Of The Middle Slide - Dürkopp Adler 806N-111-10 Service Instructions Manual

Edge folding device
2. Press Push button 1 repeatedly until middle slide and outer frame are
3. Set the adjusting wheel on the rear (1) to position 0.
 The eccentrics (2) are now automatically set to their initial position.
4. Adjust the screws in the frame of the middle slide so that the eccentrics (2)

7.3.3 Setting the alignment position of the middle slide

When the pocket blank is positioned on the middle slide, the middle slide
can be lowered using Push button 2. This position makes it to possible to
align the basic part with the pocket blank according to the pattern.
Fig. 95: Setting the alignment position of the middle slide
(1) - Push button 2
(2) - Screw
Proper setting
It must be possible to still slightly move the sewing material even if the
middle slide is lowered.
To set the alignment position of the middle slide:
1. Place the basic part and pocket blank onto the machine.
2. Press Push button 2 (1).
 The middle slide lowers.
 The middle slide is now lowered slightly above the basic part and,
3. Check and, if necessary, correct the distance between middle slide
4. Loosen the counternut (3).
5. Turn the screw (2) to move the middle slide to the correct position.
6. Re-tighten the counternut (3).
 The middle slide is now at the correct alignment position.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
lowered.
underneath abut on the middle slide without pressure. A distance of up
to 0.1 mm is acceptable.
thus, set to the alignment position.
and basic part.
① ②
(3) - Counternut
③
121