Setting The Basic Height Of The Middle Slide Relative To The Outer Frame - Dürkopp Adler 806N-111-10 Service Instructions Manual

Fig. 93: Setting the basic height of the middle slide
(1) - Piston rod
8. Leave the middle slide in the lowered position.
9. Loosen the clamping nut (2) on the piston rod (1).
10. Turn the piston rod (1) so that the sewing material under the middle
11. Tighten the counternut (2), thus locking the position of the piston rod (1).
7.3.2 Setting the basic height of the middle slide relative to the outer
The relation between middle slide and outer frame is essential for the
clean folding of the pockets.
Fig. 94: Setting the basic height of the middle slide relative to the outer frame
(1) - Adjusting wheel rear
To set the basic height of the middle slide relative to the outer frame:
1. Access User interface 2 and press the Work step by step
120
①
②
slide can be slightly moved.
frame
①
(2) - Counternut
②
(2) - Eccentric
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Edge folding device
button.