Fig. 110: Calibrating the top sewing position
(1) - Hole
To calibrate the top sewing position:
1. Remove needle and sewing foot.
2. Press the Sewing position top
The transfer plate (2) moves to the zero position.
3. Insert the 2 mm pin into the needle bar.
4. Press the Transfer plate up/down
The transfer plate lowers (2).
5. Press the Sewing head up/down
The sewing head lowers.
6. Use the arrow buttons to move the transfer plate (2) in such a way that
7. Turn the handwheel and check if the 2 mm pin plunges into the hole
8. If necessary, correct the position of the pin using the arrow buttons.
The fields holding the X and Y values will now show the coordinates.
Important
The transfer plate (2) can be shifted inside the guides by moving the trans-
fer plate (2) when lowered. It is, therefore, necessary to check the position
again and correct it if necessary.
9. Use the buttons Sewing head up/down
10. If necessary, correct the position of the pin.
11. Raise the sewing head and the transfer plate (2) again.
138
①
calibration.
the 2 mm pin is located above the upper hole (1) in the transfer plate (2).
(1) of the transfer plate (2).
down
to lift the sewing head and the transfer plate (2) once and
to lower them again.
(2) - Transfer plate
button in the submenu Position
button.
button.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Transfer carriage
②
and Transfer plate up/