Table of Contents
Advertisement
11. Move the hook case (2) sideways until the distance between the needle
12. Tighten screws (1), (3), and (4).
13. Slide the needle guard back until the conical shaft of the needle tip
14. Tighten the threaded pins of the needle guard.
15. Loosen the screws of the needle guard to move the needle guard (8)
16. Insert the middle section holder.
17. Tighten the screws on the middle section holder (5).
18. Insert the throat plate.
40
groove and the hook tip is 0.1 mm.
abuts on the hook guard with minimum deflection.
NOTICE
Property damage may occur!
The contact between needle guard (8) and hook may generate heat,
causing damage to the hook.
Set the needle guard (8) such that it does not come into contact with
the hook.
sideways.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 111
Advertisement
Table of Contents
