2. Press the buttons to enter a value between 20 and 100.
The entered value appears in the input field above.
3. Press the Confirm
The selection window closes, and the entered value appears in the
4. Press the Exit
The entered value is deleted.
5. To exit the selection window, press the Exit
The selection window closes, and you are returned to the User inter-
9.4.4 Launching DA-CAD
DA-CAD is a CAD tool that can be used to set up the pocket seam
programs.
Information
The screen you will see after launching DA-CAD depends on whether you
accessed the user interface from the Start screen ( p. 142) or from user
interface 2 ( p. 142).
146
field above the Outfeed roller speed button.
button to correct the entered value.
face intended for technicians.
NOTICE
Property damage may occur!
A transfer plate that does not fit or has been programmed incorrectly
can cause the machine to run into the transfer plate and damage the
machine.
Make sure to insert a transfer plate that fits and has been
programmed correctly.
Service settings via software
button to confirm the entered value.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
button again.