Table of Contents
Advertisement
Transfer carriage
Determining the X value
7. Press and hold the arrow button to the left until the red line on the light
8. Write down the X value.
9. Press and hold the arrow button to the right until the red line on the
10. Write down the X value.
11. Subtract the greater X value from the smaller X value.
12. Divide the result by 2.
13. Add the result to the smaller X value.
The X value for reading the coding has been determined.
14. Enter the result into the field for the X value.
Determining the Y value
15. Press and hold the arrow button upwards until the red line on the light
16. Write down the Y value.
17. Press and hold the arrow button downwards until the red line on the
18. Write down the Y value.
19. Subtract the greater Y value from the smaller Y value.
20. Divide the result by 2.
21. Add the result to the smaller Y value.
The Y value for reading the coding has been determined.
22. Enter the result into the field for the Y value.
23. Press the Confirm
24. Press the Exit
8.2.2 Calibrating the top sewing position
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
barrier symbol disappears.
light barrier symbol appears before disappearing again.
barrier symbol disappears.
light barrier symbol appears before disappearing again.
button to exit the submenu.
NOTICE
Property damage may occur!
Breakage of needle and sewing foot.
Remove needle and sewing foot prior to the position calibration.
button to save the values you entered.
137
Advertisement
Table of Contents
