Machine head 111
To set the position of the counter blade in relation to the thread-pulling
knife:
1. Press the Lift/lower sewing head
The sewing head lowers.
2. Press the O button.
Threading mode is switched on.
3. Loosen the screws (3) and shift the counter blade support/counter
4. Re-tighten the screws (3).
Important
An excessive counter blade pressure will result in increased knife wear.
4.11.5 Setting the position of the hook thread clamp
Fig. 37: Setting the position of the hook thread clamp
(1) - Hook thread clamp
(2) - Thread-pulling knife
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
blade accordingly.
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
button.
③
(3) - Screws
②
59