Setting The Height Of The Throat Plate - Dürkopp Adler 806N-111-10 Service Instructions Manual

4.2.5 Setting the height of the throat plate

Fig. 11: Setting the height of the throat plate
(1) - Screw
Proper setting
The surface of the throat plate (not the throat plate insert) should be
0.5 mm below the upper side of the base plate.
To set the height of the throat plate:
1. Press the Lift/lower sewing head
 The sewing head lowers.
2. Press the O button.
 Threading mode is switched on.
3. Loosen the screw (1).
4. Turn the block (2) accordingly.
5. Tighten the screw (1).
32
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 111
②
(2) - Block
button.