Dürkopp Adler 806N-111-10 Service Instructions Manual page 4

4.11.7 Setting the swivel range of the thread-pulling knife .................... 62
4.11.8 Setting the position of the roller lever in relation to the
5
5.1
5.1.1 Gage set ..................................................................................... 67
5.1.2 Integrated adjusting disk............................................................. 68
5.1.3 Setting the position of the integrated adjusting disk relative
5.2
5.3
5.4
5.5
5.6
5.6.1 Setting the winder ....................................................................... 76
5.6.2 Canceling cylindrical winding...................................................... 77
5.6.3 Exchanging the friction ring ........................................................ 78
5.6.4 Resetting the winder wheel ........................................................ 79
5.7
5.8
5.8.1 Setting the loop stroke and hook tip distance to the needle ....... 81
5.8.2 Aligning the hook drive housing.................................................. 82
5.8.3 Aligning the bobbin case support ............................................... 84
5.8.4 Setting the throat plate ............................................................... 85
5.8.5 Setting the needle guard ............................................................ 87
5.9
5.9.1 Setting the control cam for timing the knife movement............... 89
5.9.2 Setting the position of the stationary knife .................................. 90
5.9.3 Regrinding the stationary knife ................................................... 91
5.9.4 Installing the thread guide plate.................................................. 92
5.9.5 Setting the thread-pulling knife ................................................... 93
5.9.6 Setting the cutting pressure ........................................................ 95
5.10
5.11
5.11.1 Setting the lower position of the machine arm............................ 98
5.11.2 Setting the speed of the machine arm ........................................ 99
5.11.3 Setting the end position damping of the cylinder ...................... 100
6
6.1
6.2
6.2.1 Setting the lateral outfeed roller position .................................. 103
6.2.2 Setting the lateral stacker position............................................ 104
6.3
6.3.1 Setting the lower outfeed roller position ................................... 105
6.3.2 Setting the movement of the ejection rollers ............................ 106
6.4
6.5
6.6
6.7
2
control cam ................................................................................. 63
Machine head 121 ..................................................................... 65
Adjustment aids .......................................................................... 67
to the arm shaft........................................................................... 69
Setting the sewing foot height .................................................... 71
Setting the needle thread tension release .................................. 73
Setting the thread tensioning spring ........................................... 74
Setting the needle thread regulator ............................................ 75
Winder ........................................................................................ 76
Setting the needle bar height...................................................... 80
Hook settings .............................................................................. 81
Thread cutter .............................................................................. 88
Replacing the right arm shaft bearing......................................... 96
Machine arm position ................................................................. 98
Stacker..................................................................................... 101
Rotating the stacker tray........................................................... 102
Lateral position of outfeed roller and stacker............................ 102
Outfeed roller ............................................................................ 105
Setting the position of the open inner shackle .......................... 107
Setting the movement of outer and inner shackle and of
the tray...................................................................................... 108
Setting the sensitivity of the light barrier ................................... 110
Setting the air nozzle ................................................................ 111
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Table of Contents