Dürkopp Adler 806N-111-10 Service Instructions Manual page 21

Basic setting
1. Place the cover on the carriage from above.
2. Insert the cover so that it lies on the cover of the edge folding station (1).
1. Insert the cover at the top right into the guide of the carriage (5).
2. Insert the thread reel holder from above.
3. Tighten the clamping lever on the thread reel holder by reaching under
4. Lock the cover lock using the associated key.
Covers below the table level
To assemble the covers below the table level in the correct order:
1. Insert the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Insert the cover into the guide hooks at the top.
 The cover is locked in place by the springs on the guide hooks.
4. Fit the plate.
5. Fasten the plate with the screws.
1. Insert the cover downwards into the guide hooks.
2. Pull the cover upwards.
3. Insert the cover into the guide hooks at the top.
 The cover is locked in place by the springs on the guide hooks.
4. Slide the retaining bar into the guide.
5. Fasten the screws on the retaining bar.
1. Insert the cover into the guide hooks at the bottom.
2. Pull the cover upwards.
3. Insert the cover into the guide hooks at the top.
 The cover is locked in place by the springs on the guide hooks.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Carriage cover (5)
Sewing head cover (6)
the cover.
Right side cover (9)
Left side cover (2)
Left and right rear covers (10)
19