Setting The End Position Damping Of The Cylinder - Dürkopp Adler 806N-111-10 Service Instructions Manual

5.11.3 Setting the end position damping of the cylinder

Fig. 74: Setting the end position damping of the cylinder
(1) - End position
The speed of the piston rod is reduced approximately 10 mm from the end
position in order to brake the heavy sewing head gently.
Proper setting
The piston rod should move gently into both end positions.
To set the end position damping of the cylinder:
1. Press the Lift/lower sewing head
Set the end positions (1) and (2) accordingly.
100
WARNING
Risk of injury from moving parts!
Crushing.
Do not reach into the area of moving machine
parts.
①
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 121
②
(2) - End position
button repeatedly.