Setting The Segment End/Seam End Parameters - Dürkopp Adler D669 Operating Instructions Manual

Icon Parameter
Parameter Seam End
Sewing stop
Adjustments for seam end bartack parameters
Bartack at seam end
Number of stitches backwards
Number of stitches forward
124
5.8.7.2 Setting the Outputs (Output) parameter
This parameter provides virtual outputs that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the
machine.
This parameter cannot be used unless the virtual outputs have
been assigned to a physical output at the Technician level. This
requires that the parameter Additional I/O Configuration
can be configured at the Technician level; for more details, refer
to the explanation in the  Service Instructions.
5.8.8

Setting the Segment End/Seam End parameters

There are various options for setting the Segment End parameters.
The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Operating Instructions D669 M-TYPE DELTA - 00.0 - 10/2020
Setting
Value range
On/Off
Setting as to what will happen at
the end of a segment/seam.
(see  p. 127)
Value range
On/Off
Value range
01 - 50
Value range
01 - 50
Programming