Setting The Sensitivity Of The Light Barrier - Dürkopp Adler 806N-111-10 Service Instructions Manual

6.6 Setting the sensitivity of the light barrier

Fig. 84: Setting the sensitivity of the light barrier
(1) - Plate
(2) - Screw
To correct the sensitivity of the light barrier:
1. Set the screw (2) through the sight opening of the light barrier.
2. Use a piece of fabric to check the setting of the light barrier.
3. Slide the fabric piece under the light barrier across the plate (1).
 The yellow lamp (3) will go out if the setting of the light barrier is
 If the setting is incorrect, the yellow lamp (3) is off or flickering.
110
①
• To increase the sensitivity of the light barrier: Turn screw (2) clock-
wise
• To reduce the sensitivity of the light barrier: Turn screw (2) counter-
clockwise
correct.
(3) - yellow lamp
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Stacker
③
②