Setting The Range Of The Rocker Oscillation (Zigzag Stitch Width) - Dürkopp Adler 806N-111-10 Service Instructions Manual

4.2.3 Setting the range of the rocker oscillation (zigzag stitch width)

Fig. 9: Setting the range of the rocker oscillation (zigzag stitch width)
(1) - Stop screw
(2) - Counternut
Proper setting
In zigzag mode of the machine, the upper and the lower punctures on a
piece of paper should have a distance of 4.6 mm. For a sewn-on pocket
this will result in a zigzag stitch width of approx. 3 mm, depending on the
type of fabric and thread used and on the thread tension.
1. Press the Lift/lower sewing head
 The sewing head lowers.
2. Press the O button.
 Threading mode is switched on.
3. Press the Zigzag
4. Place a sheet of paper on the sewing material support surface and
5. Turn the adjusting wheel (3).
6. Turn the counternut (2) and the stop screw (1) accordingly.
30
WARNING
Risk of injury from moving parts!
Crushing.
The machine must be set to Threading mode.
①
hold it there.
②
(3) - Adjusting wheel
button.
button.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Machine head 111
③