Dürkopp Adler 806N-111-10 Service Instructions Manual page 12

Inspect the machine while in use for any externally visible damage.
Operation
Stop working if you notice any changes to the machine. Report any changes
to your supervisor. Do not use a damaged machine any further.
Safety equipment should not be removed or deactivated. If it is essential
Safety
equipment
to remove or deactivate safety equipment for a repair operation, it must be
assembled and put back into operation immediately afterward.
The safety equipment is located at the illustrated positions on the machine:
Fig. 1: Safety equipment
(1) - Protective covers
(2) - EMERGENCY STOP button
The following safety equipment are mounted on the machine:
10
① ②
Figure Naming
EMERGENCY
STOP button
EMERGENCY
STOP
integrated
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
③
(3) - Integrated EMERGENCY STOP
(4) - Metal bar
Purpose
The machine is immediately placed
in the EMERGENCY STOP state:
– The motors are braked and then
disconnected from the power.
– The cylinders are depressurized.
The machine is immediately placed
in the EMERGENCY STOP state:
– The motors are disconnected
from the power.
– The cylinders are depressurized.
Safety
④