Setting The Movement Of Outer And Inner Shackle And Of The Tray - Dürkopp Adler 806N-111-10 Service Instructions Manual

9. Trigger an EMERGENCY STOP.
10. Perform a reference run.
6.5 Setting the movement of outer and inner shackle and of
Fig. 82: Setting the movement of outer and inner shackle and of the tray (1)
(1) - Inner shackle
(2) - Outer shackle
Proper setting
Shackles and tray must be set as follows:
108
the tray
WARNING
Risk of injury from moving parts!
Crushing.
Do NOT reach into the area of moving parts.
①
• All elements should move swiftly and evenly.
• The outer shackle (2) should be opened all the way when the work-
piece is ejected.
• The tray (3), which is swinging forward, should reach the workpiece
hanging from the sewing material support surface at the same time
as the inner shackle (1). This requirement must be met to ensure
that the workpieces are clamped and stacked properly.
(3) - Tray
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Stacker
③
②