Adjusting The Proximity Switch For The End Position - Dürkopp Adler 806N-111-10 Service Instructions Manual

7.6 Adjusting the proximity switch for the end position

Fig. 104: Adjusting the proximity switch for the end position (1)
(1) - Proximity switch
Information
The proximity switches (1) are taught automatically during initial startup.
During Auto Teach-In, every stop > 100 ms of the piston is output as a
switching point within the detection range. If the piston reverses its direc-
tion of movement at this position and exits the detection range without
making an additional stop, this switching point is saved to temporary mem-
ory.
If the piston stops at the same position 4x in a row, reverses its direction
of movement and exits the detection range without making an additional
stop, this position is saved as the final switching point.
Auto Teach-In is complete.
If the switching window is too narrow, you can use the capacitive control
button to adjust it.
Fig. 105: Adjusting the proximity switch for the end position (2)
(1) - Proximity switch
(2) - Detection range marking
(3) - Fastening screw
130
①
①
②
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
Edge folding device
⑤
④
③
(4) - Capacitive user button
(5) - LED