Dürkopp Adler 806N-111-10 Service Instructions Manual page 27

Machine head 111
Fig. 5: Setting the position of the rocker (1)
(1) - Gear wheel
(2) - Gear wheel
Proper setting
The needle should plunge into the center of the 2 mm hole of gage 3
(part no. 0804 400270) when the machine is not set to zigzag mode.
Fig. 6: Setting the position of the rocker (2)
(4) - Screws
(5) - Setting block
Correction in X direction
1. Press the Lift/lower sewing head
 The sewing head lowers.
2. Press the O button.
 Threading mode is switched on.
3. Loosen the screws (4) on the setting block (5).
4. Loosen the clamping screw (7) on the drive lever (6).
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
①
②
④
⑤
③
(3) - Gage
⑥ ⑦
(6) - Drive lever
(7) - Screw
button.
25