Dürkopp Adler 806N-111-10 Service Instructions Manual page 111

Stacker
Fig. 83: Setting the movement of outer and inner shackle and of the tray (2)
(1) - Throttle valve - close outer shackle
(2) - Throttle valve - open outer shackle
(3) - Throttle valve - close inner shackle
To set the movement of outer and inner shackle and of the tray:
1. Start the automatic sewing process.
2. Watch the speed and movement of shackles and tray while the work-
3. Set the speed of the movement by regulating the throttle valves shown
4. Check the movement of the elements during the automatic sequence.
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
①
②
pieces are being stacked.
in the figure Setting the movement of outer and inner shackle and of
the tray (2) ( p. 109).
• To set a faster movement speed: Turn the screws on the throttle
valves counterclockwise
• To set a slower movement speed: Turn the screws on the throttle
valves clockwise
④ ⑤
③
(4) - Throttle valve - open inner shackle
(5) - Throttle valve - swivel tray down
(6) - Throttle valve - swivel tray forward
⑥
109