Setting The Stop Positions Parameters - Dürkopp Adler D869 e-con Service Instructions Manual

17.4.4 Setting the Stop Positions parameters

Various settings can be made for the stop positions. The possibilities are
explained in more detail in the table.
Icon
122
Menu items
Lower needle position
Holding position of the needle in
the material.
Threading position
Position for the proper function of
the threader, e.g. with thread lever at top
dead center.
Needle up position
Holding position of the needle outside of
the material.
Position of the needle after
turn back
Stop position after thread cutting
(reversal position).
Length Pos. 1 - Signal
Length Pos. 2 - Signal
On Pos-Signal
Length Pos. - Signal
Change speed on position
Position of speed change
Service Instructions D869 e-con - 00.0 - 09/2023
Programming
Value range
• Value range
000 - 359 [°]
• Value range
000 - 359 [°]
• Value range
000 - 359 [°]
• Value range
000 - 359 [°]
• Value range
000 - 359 [°]
• Value range
000 - 359 [°]
• Value range
000 - 359 [°]
• Value range
000 - 359 [°]
• Value range
On/Off
• Value range
000 - 330 [°]