Setting The Thread-Pulling Knife - Dürkopp Adler 806N-111-10 Service Instructions Manual

Machine head 121

5.9.5 Setting the thread-pulling knife

Fig. 67: Setting the thread-pulling knife (1)
(1) - Screws
(2) - Thread-pulling knife
(3) - Triangle
(4) - Thread guide plate
Fig. 68: Setting the thread-pulling knife (2)
(1) - Screws
(2) - Thread-pulling knife
Proper setting
The thread-pulling knife (2), as viewed in arrow direction, must rest against
the two screws (1).
In neutral position of the thread-pulling knife, its tip (6) and the cutting
edge (7) must be flush with the stationary knife (5).
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
①
② ③
①
⑤
WARNING
Risk of injury from sharp parts!
Cutting.
Only set the thread-pulling knife with the machine
switched off.
④ ⑤ ⑥ ⑦
(5) - Knife
(6) - Tip
(7) - Cutting edge
(8) - Screw
②
(5) - Knife
(9) - Line
⑧
⑨
93