Setting The Outfeed Roller Speed - Dürkopp Adler 806N-111-10 Service Instructions Manual

Service settings via software
2. Press the buttons to enter a value between 20 and 100.
 The entered value appears in the input field above.
3. Press the Confirm
 The selection window closes, and the entered value appears in the
4. Press the Exit
 The entered value is deleted.
5. To exit the selection window, press the Exit
 The selection window closes, and you are returned to the User inter-

9.4.3 Setting the outfeed roller speed

You can set the speed of the outfeed roller. The speed is indicated in %.
The setting does NOT affect the roll-out length, but merely applies to the
ejection of the sewing material. If the material is not ejected fast enough,
the sewing material may not properly rest on the stacker.
To set the speed of the outfeed roller:
1. Press the Outfeed roller speed
 The following window appears:
Fig. 119: Setting the outfeed roller speed
Service Instructions 806N-111-10/806N-121-10 - 00.0 - 09/2023
field above the Transfer plate speed button.
button to correct the entered value.
face intended for technicians.
button to confirm the entered value.
button.
button again.
145