Stop Positions; Foot - Dürkopp Adler 650-10 Service Instructions Manual

4.4.5 Stop Positions

In the submenu Stop Positions, you can determine the position of the
needle when sewing stops. The position is specified by entering degree
values. The position is 0° when the needle is at top dead center. The re-
maining handwheel positions can be inferred accordingly. 360° corre-
sponds to one complete handwheel rotation.
Fig. 52: Stop Positions
Parameters in the submenu Stop Positions

4.4.6 Foot

In the submenu Foot, you can define the settings for sewing foot lifting.
Fig. 53: Foot
Parameters in the submenu Foot
64
Icon Entry Meaning
StopIdle° Handwheel position after cut-
ting the thread and reversal
StopTop° Handwheel position in the
needle's upper idle position
when sewing stops
StopBottom° Handwheel position in the
needle's lower idle position
when sewing stops
Icon Entry Meaning
FL AtStop Sewing foot rises when
sewing stops
FL AfterTrim Sewing foot rises after
cutting the thread
FL height Sewing foot position when
raised
Service settings via software (OP3000)
35
0
130
Possible value
range
0 – 359
0 – 359
0 – 359
0
0
30
Possible value
range
0 = off
1 = on
0 = off
1 = on
5 – 14
Service Instructions 650-10 - 01.0 - 08/2016
Preset value
35
0
130
Preset value
0
0
12