Removing A Head Station From The Din-Rail - WAGO 750 Series Manual

Assembly and Disassembly
3. Check that the I/O module is seated securely on the DIN-rail and in the assembly.
ð Once the I/O module has snapped into place, the electrical connections are establish
for the data contacts and power contacts (if any) to the head station or to the preced-
ing and, if applicable, following I/O module.
Adding the Wiring Interface of the 753 Series
1. Make sure that the locking tab of the I/O module is not pulled out.
2. Place the wiring interface on the I/O module.
3. Press the wiring interface onto the I/O module until it clicks into place completely.

7.5 Removing a Head Station from the DIN-Rail

Follow these steps to remove a head station from a DIN-rail:
48 System manual | Version: 3.3.1
Figure 25: Snapping the I/O Module On
Figure 26: 753 Series Wiring Interface and I/O Module
Serie 750, 753