WAGO-I/O-SYSTEM 750
750-354/000-001 EtherCAT® Fieldbus Coupler, ID Switch
Figure 9: Supply Module with Fuse Carrier (Example 750-610)
Observe the maximum power dissipation and, if required, UL requirements!
In the case of power supply modules with fuse holders, you must only use fuses
with a maximum dissipation of 1.6 W (IEC 127).
For UL approved systems only use UL approved fuses.
In order to insert or change a fuse, or to switch off the voltage in succeeding I/O
modules, the fuse holder may be pulled out. In order to do this, use a screwdriver
for example, to reach into one of the slits (one on both sides) and pull out the
holder.
Figure 10: Removing the Fuse Carrier
System Description
Manual
Version 1.2.1
31