Table 76: Wbm "Routing" Page - "Port Forwarding" Group - WAGO Compact Controller 100 Manual

WAGO I/O System Compact
751-9301 Compact Controller 100
"Port-Forwarding" Group
Each entry has its own area in the display.
Table 76: WBM "Routing" Page – "Port Forwarding" Group
Parameters
Enabled
Interface
Port
Protocol
Destination Address
Destination Port
Click the [Submit] button to apply the changes. The changes take effect
immediately.
Click the [Add] button to add a new entry. The change takes effect immediately.
Click the [Delete] button to delete an existing entry. The change takes effect
immediately.
An entry is only transferred to the system if "Enabled" is enabled in the "General
Routing Configuration" group. This allows you to configure a default setting that is
not applied until the general switch-on.
Explanation
Specify whether port forwarding should be used.
Disabled Port forwarding is not used.
Enabled Port forwarding is used.
You can select the specified name of a network
interface. Alternatively, selecting "other" allows you
to specify any network interface name.
Enter the port here on which the product receives
network data packets to be forwarded.
You can select the protocol to be used for the port
forwarding. The options are TCP, UDP or both
protocols.
Specify the network address of the destination
device. This address replaces the original
destination address of the network data packet.
Specify the port number of the destination device.
This value replaces the original destination port of
the network data packet.
Version 1.1.0, valid from FW Version 03.08.07(20)
Appendix 147
Manual